Russound R290DS User Manual download pdf (Page 8)

8 Russound R290DS Installation Manual

SYSTEm CONFIGURATION - BRIDGED mODE

Bridged Mode

In this mode both the left and right channels are combined for a higher power

mono output. For proper operation, the left channel adjustment should be set

to the center position to start and then adjusted appropriately from there. The

right channel adjustment is not applicable.

Unplug the R290DS. 1.

Set the Stereo/Bridge switch to Bridge Mono. 2.

Connect the line out from a preamplier or source to the Left Primary input 3.

jack of the R290DS. Do not connect any input to the right side, it will be

ignored.

Connect the negative lead (-) of the speaker cable to the R(+) terminal. 4.

Connect the positive lead (+) of the speaker cable to the L(+) terminal. (See

the markings above the terminals on the rear panel). An 8 Ohm minimum

load is recommended.

Restore power to the amplier. 5.

Bridged Mode Conguration

R290DS Amplier

8 Ohm Speaker

Line out from Source

(+) Positive Speaker Cable

(-) Negative Speaker Cable

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Russound R290DS User Manual Page 8